Intellimute Pro; Voice/Tone Setting - Cobra SPX 5500 Important Information Manual

Settings
Your Detector

IntelliMute Pro

IntelliMute Pro prevents detection by radar detector detectors (RDDs) such
as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is
intended for use by experienced users only.
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
activation point, your detector's radar detection circuits are turned Off to
prevent detection by RDDs.
Before IntelliMute Pro can be turned On, you must have turned On and Set
the IntelliMute activation point. (See pages 9 through 11.)
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
To Turn IntelliMute Pro On
While no signal
Tone
is being detected,
Two beeps
press and hold both
the IntelliMute and
City buttons for four
seconds.
To Turn IntelliMute Pro Off
Press and hold both
Tone
the IntelliMute and
One beep
City buttons for four
seconds.
12 English
IntelliMute Button
IntelliMute Pro On
City Button
Press and hold both
i h
buttons simultaneously
NOTE
The arrow up or down will continue
to show that engine RPMs are
above or below the user-set value.
Voice
Visual Display
IntelliMute Pro On i blinks continuously
in the display after
IntelliMute Pro On
blinks
Voice
Visual Display
IntelliMute Pro Off None, after
IntelliMute Pro Off
blinks
Settings
Your Detector

Voice/Tone Setting

You can set your detector to sound alerts with either a Voice or a Tone.
You can change settings by using the Mute button.
In Voice Alert mode, you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In Tone Alert
mode, you will hear the tones only. The factory setting is Voice Alert mode.
Mute Button
Press and hold for
two seconds
To Change From Voice Alert to Tone Alert
While no signal
Tone
is being detected,
One beep
press and hold
the Mute button
for two seconds.
To Change From Tone Alert Back to Voice Alert
While no signal
Tone
is being detected,
None
press and hold
the Mute button
for two seconds
again.
Voice
Visual Display
Tone Alert None, after
Tone blinks in
the display
Voice
Visual Display
Voice Alert None, after
Voice blinks in
the display
Nothing Comes Close to a Cobra
®
13