Battery Voltage; Menu-User Settings; Menu-Alert Settings; Detail - Cobra RAD450 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty
MUTE Button
Assistance
Manual Mute: Your detector allows you to quickly turn OFF an audio alert by
momentarily pressing the MUTE button. If you press the MUTE button a second
time during the alert, the audio alert will be turned back ON.
Secondary Icons
When an alert is being muted the audio icon on the display will
change to:
Quiet Drive is a muted driving mode for times when a driver wants less audible

Notice

feedback while talking with passengers, on the phone, etc. Only the first few
seconds of audio will be heard. This mode is Off by default.
This mode can be changed in the User Settings menu or by
pressing and holding the MUTE button for two seconds. When
Quiet Drive is on the audio icon on the display will change to:

Battery Voltage

To display your vehicle's battery voltage, press the MUTE button while no signal
is being detected.

DIM Button

You can choose from four settings for the brightness of the display. Repeatedly
push the DIM button to cycle through the settings. The factory setting is Bright.
MENU Button
Menu - User Settings
To change the User settings enter the Menu by pressing the MENU button. A voice
announces "Menu" and the display will change to
USER MENU
Press the DIM button to enter the User settings menu.
Press the MUTE or MENU
buttons to switch between the User settings.
Press the DIM or SEN buttons to change the selected User setting's value.
The value that is shown on the display is the selected value. To exit the menu
simply wait several seconds or select Exit Menu.
6 English
•
ALERT
Settings
Your Detector
Intro Operation Customer Warranty
Menu - User Settings continued
Assistance
USER SETTING VALUE

Detail

More*/Less
Secondary Icons
Quiet Drive Off*/On
Auto Mute Off/On*
Voice Off/On*

Language

English*/Spanish
Notice

IntelliMute

Off*/On/Set
Screen Saver Off/1 Minute*/3 Minute
Low V. Warning Off*/On
Smart Power Off*/On
System Info Press the SEN button to display system information.
Restore Defaults Press the SEN button to restore factory default settings
then press SEN button again to confirm.
Exit Menu Press the MUTE button to exit the menu.
* = Factory default setting
Menu - Alert Settings
To change the Alert settings enter the Menu by pressing the MENU button.
A voice announces "Menu" and the display will change to
USER MENU
Press the SEN button to enter the Alert settings menu.
Press the MUTE or MENU
buttons to switch between the Alert settings.
Press the DIM or SEN buttons to change the selected Alert setting's value.
The value that is shown on the display is the selected value. To exit the menu
simply wait several seconds or select Exit Menu.
•
•
ALERT
Nothing Comes Close to a Cobra 7
®