Electric Requirements - Insignia NS-TDRE67W1-C User Manual

For best results, the static pressure in any exhaust system should be between 0.3
to 0.8 inches of water column, and it cannot be less than 0 under any
circumstances with an installed duct with a four inch diameter. Measurement
must be done with the empty dryer working with a manometer at the point where
the exhaust duct connects to the dryer. A no-heat setting should be used. Lint
filter must be clean.
# of 90°
elbows
0
1
2
3

Electric requirements

WARNING:
The wiring diagram is located on the back panel of your dryer.
• Incorrectly connecting your dryer's grounding conductor can result in electric
shock. Check with a qualified electrician or serviceman if you are in doubt as
to whether your dryer is correctly grounded. Do not modify the plug
provided with your dryer. If the plug does not fit the outlet, have the correct
type outlet installed by a qualified electrician.
• To prevent unnecessary risk of fire, electrical shock, or personal injury, all
wiring and grounding must be done in accordance with local codes, or in the
absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70 -
Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1-Latest
Revisions and local codes and ordinances (for Canada). You are responsible
for providing adequate electrical services for your dryer.
• All gas installations must be done in accordance with the latest revision of
National Fuel Code ANSI Z223.1/NFPA 54 (for US) or CSA B149.1 (for Canada)
and local codes and ordinances.
18
INSTALLATION INSTRUCTIONS
WEATHER HOOD TYPES
Recommended
4 in.
(10.2 cm)
Rigid Metallic
90 ft. (27.4 m)
60 ft. (18.3 m)
45 ft. (13.7 m)
35 ft. (10.7 m)
www.insigniaproducts.com
Use only for short-run
installation
2 1/2 inch.
(6.4 cm)
Rigid Metallic
60 ft. (18.3 m)
45 ft. (13.7 m)
35 ft. (10.7 m)
25 ft. (7.6 m)