hergom Pas II Owner's Manual page 11

THE ENAMELLED WORKTOP COMPONENTS
To keep the worktop looking good, we recommend cleaning it frequently using a damp cloth.
Do not use acidic or abrasive products to clean the worktops as these products can damage the
vitreous enamel. See the comments for Ceramic glass above.
STAINLESS STEEL FRAMEWORK
To take care of the stainless steel, use dedicated stainless steel cleaners available in the market.
Avoid any utensils that may scratch the stainless steel, it is important that the outer surface is not
damaged.
EMPTYING THE ASHES
The special design of the stove in heat-resistant material, which makes it possible to make maximum
use of the fuel, means that the volume of ashes produced is low.
This makes it possible to light the stove repeatedly without needing to remove them from the stove.
When it is necessary to carry out this operation, remove the grill from the stove and move the ashes
to the ashtray. Empty the ashtray into a metal container and take it out of the house immediately.
Leave a bed of Ash in the base on the grate to insulate the fire and keep it burning, but never leave
the ash tray full so the soot has filled up all the space at the bottom of the cast grate, this can
damage the grate casting from overheating
During the annual cleaning, or when necessary, check that the hob cooktop is in good condition and
sealing with the cooker. If necessary, change the glass tape liner or change the hotplate. This plate is
simply inserted in the frame, and its replacement is a very simple operation.
11