Settings used
For the configuration example, the devices are given the following IP address settings:
Device
PG/PC
SCALANCE M874-3
You configure SCALANCE M874-3 with the programming device / PC via Web Based
Management. To do so, you must assign the IP address to the PC network adapter. In the
extended TCP/IP settings of the network adapter configuration you have the option of adding
additional IP addresses.
Note
You can also use another SCALANCE M-800/S615 device. The configuration described below
relates to the SCALANCE M874-3.
Note
The IP settings used in the configuration example were freely chosen.
In a real network, you would need to adapt these IP settings to avoid possible address
conflicts.
Requirement
• SCALANCE M874-3
– Firmware version 6.3
– The device is accessible via the PG/PC and you are logged on to the WBM as
– The device is connected to the CPU via the PNI interface.
• PG/PC
– TIA Portal V15 Update 4 is installed.
Steps in configuration
The following steps are required to read out the diagnostic buffer:
1. Enabling the integrated TIA Portal Cloud Connector on the device (Page 42)
2. Enabling the TIA Portal Cloud Connector on the PG/PC (Page 43)
3. Connecting to the TIA Portal Cloud Connector (Page 45)
Cloud Connector
Getting Started, 07/2020, C79000-G8976-C507-03
VLAN
VLAN1
P1 (VLAN1)
"Administrator".
You can find more information on this in the "SCALANCE M-800 Getting Started
(https://support.industry.siemens.com/cs/ww/en/view/78389746)".
IP address
192.168.16.10
255.255.255.0
192.168.16.84
255.255.255.0
PROFINET connection
3.1 Local service
41