STIEBEL ELTRON DHC-E 3/3.5-1 Trend Operation And Installation Manual page 9

OPERATION
Settings and displays
For the name of each display element on the DHC-E Trend, consult
section 5.1.1, "DHC-E Trend display overview", pg. 7.
5.4.1 Base display
The base display shows the current temperature setpoint in your
preferred temperature unit. The bar below the temperature shows
the current operating capacity. As the hot water demand fluctuates,
the power capacity status will change to show between 0 and 10
segments. The display below shows that the water heater is oper-
ating at 40% of full capacity.
All other menu displays will revert back to the base display either
after a 15-second period of time without user input, or after a 5-sec-
ond hold of the T button.
max
Changing the setpoint temperature
Temperature settings
Range Increment
68–140 °F 1 °F
The setpoint temperature can be set between 68 °F (20 °C) and 140 °F
(60 °C).
The setpoint can be increased by turning the control knob clockwise,
and decreased by turning it counter-clockwise. The water heater
can be deactivated while still powered by turning the control knob
counter-clockwise, past the 68 °F (20 °C) setting.
5.4.2 Parameters menu
While at the base display, holding the T
advance the display to the first parameter menu.
T parameter setting
max
The first parameter menu sets the value for T
acts as a high temperature limiter. If the T
point of the water heater cannot be set above the T
feature is useful in scenarios where scalding from hot water is a
real possibility.
www.stiebel-eltron-usa.com
Range Increment
20–60 °C. 0.5 °C
button for 5 seconds will
max
. The value of T
max max
value is set, the set-
max
value. This
max
At the T setting menu, the display will flash, indicating that the
max
value can be changed by rotating the control knob. The T
can be increased by turning the control knob clockwise, and de-
creased by turning it counter-clockwise. The T
activated by turning the control knob counter-clockwise, past the
68 °F (20 °C) setting. The display will read "Off" if T
If the T symbol is visible at the base display, then the T
max
tion is active and is limiting the maximum allowable temperature
to the preset level.
Pressing the T button once while at this display will move the
max
display onto the temperature units parameter setting.
Temperature units parameter setting
The DHC-E Trend is capable of displaying temperature in either Fahr-
enheit or Celsius.
The current unit will be shown and the display will be flashing to
indicate that the value can be changed. Rotate the control knob to
change the value between Fahrenheit and Celsius.
Pressing the T button once while at this display will move the
max
display onto the display-lock parameter setting.
Display-lock parameter setting
The display can be locked to prevent changes to the temperature set-
point. This menu will flash, indicating that the value can be changed
by rotating the control knob. While the display shows "Off", the lock
is not active. The lock is active when it reads "On".
If the display-lock parameter is set to "On" and the user either holds
the T button for 5 seconds or lets the display time out for 15
max
seconds, the display-lock will become active.
max
value can be de-
max
is inactive.
max
max
DHC-E Trend & DHC-E Plus |
value
func-
9