Advertisement
(6) Remov
(6)
Remove the T
e the Taptite bi
aptite bind B M3x10 screw
front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/
front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/
rear sensor harness from the Hole.
rear sensor harness from the Hole.
Registration front/rear actuator
Registration front/rear actuator
holder ASSY
holder ASSY
Hook
Hook
Registration front/rear
Registration front/rear
sensor harness
sensor harness
Registration chute
Registration chute
Hole
Hole
Harness routing: Refer to
Harness routing: Refer to "
"
Assembling Note:
Assembling Note:
• • After asse
After assembling the Regi
mbling the Registratio
chute, push the Actuators by fingers and check if they are pushed back by their springs
chute, push the Actuators by fingers and check if they are pushed back by their springs
(if the springs are not caught at assembling).
(if the springs are not caught at assembling).
<Top side>
<Top side>
nd B M3x10 screw. Release eac
. Release each Hook, and remov
Hook
Hook
Hooks
Hooks
<Bottom side>
<Bottom side>
Fig. 3-102
Fig. 3-102
12.
12
.
T
T
op side of
op side of
the registration chute
the registration chute
stration front/rea
n front/rear actuator hold
r actuator holder ASSY to the Registratio
Fig. 3-103
Fig. 3-103
h Hook, and remove the Regist
e the Registration
Taptite bind B M3x10
Taptite bind B M3x10
"
"
. .
er ASSY to the Registration n
Actuators
Actuators
Registration chute
Registration chute
ration
Advertisement
