Charging The Battery; How To Remove And Insert The Battery; Before Starting To Ride; Mount Or Dismount Front Wheel - Evinci infinity HD Series User Manual

Charging the battery

1. Open the plug cover at the right side of the battery (#5)
2. Connect charger cord to the battery
3. Connect the power cord to a mains socket

How to remove and insert the battery

1. Removal: unlock the battery lock at the left side of the battery
2. Slide battery upwards and then lift it out of the rail
3. Insert: Slide the battery into the battery rail, secure it in the frame with
the battery lock

Before starting to ride

Mount or dismount front wheel

For easy transport, you may remove the front
wheel using the quick release at the front wheel
axle.
To remove the wheel flip the lever into the open
position. Now hold the lever and turn the bolt
on the other side about 8-9 times to loosen the
axle – do not remove the bolt! You should be
now able to lift the wheel out of the fork.
To mount the wheel repeat procedure the other way round. Guide the rotor in
between the brake pads. Hold the lever pointing parallel to the fork in the open
position (downwards), turn the bolt till you feel a slight resistance. Try to close
the lever – if it is too hard to do so, loosen the bolt a bit and try again.
You may charge the battery on the bike or remove it to a
more convenient place.
The charger will get hot during charging – do not cover while
in use as it might cause a malfunction.
Before every ride make sure the quick release is tightened
properly. To fail so can lead to serious injuries!
Never squeeze the brake lever without the wheel fitted!
9