Brakes; Maintenance; Gears - Evinci infinity HD Series User Manual

at too low revelations, change to a lower gear. If you pedal very fast with less
effort, choose a higher gear or reduce the assistance level.

Brakes

We recommend always using both brakes at the same time – this allows the
rider to take the best control over the braking process without stressing the
front or rear brake. To brake efficiently, your front brake is there to stop you
and the back brake is there to shave off speed. Roughly 70-80% of your
stopping power comes from the front brake. Leaving 20-30% for the back
brake.

Maintenance

Your infinity e-bike needs regular maintenance as any other normal pushbike.
All bike shops can help you with these maintenance steps.
There is no maintenance necessary of the electrical components.
Brakes
This bike uses high performance hydraulic brakes which are self-adjusting. If
you feel that the brake force gets lower or you hear unusual noises then most
likely the brake pads have to be replaced. Please see your local bike shop.

Gears

Our infinity bike uses a solid and easy to maintain
Shimano Deore gear system.
It can happen after a while that gears do not
perfectly change anymore or you experience a
rattling noise while pedalling. This is normal due
to the nature of the used control wire hulls which
can get compressed over time. To re-adjust it is
usually enough to slightly tighten the gear wire.
When you intend to stop it is good practice to change the
gear back to a lower gear so you may start without any
problems. This can easily be done while braking and slowly
pedalling as the motor will not push you further.
Please note that this bicycle uses high performance hydraulic
brakes with no special motor cut-out. When going around
narrow corners adjust the power support to prevent
unexpected high acceleration.
14