Toyota 4Y 2006 Manual page 171

Hose
clamps
Fuel pump
Pipe
Hose
[Point 21
Removal:
Disconnect the fuel tank cover pipe and the fuel hose.
Note:
Make sure to use two wrenches when loosening.
[Point 31
Removal:
Loosen the hose clamps, and remove the fuel pump ASSY.
[Point 41
Inspection:
Apply the battery voltage between the terminals, and check
that the motor runs.
Caution:
Inspection should be performed in a short period of time
(within 5 seconds).
Bring the pump away from the battery as far as possible.
Carry out the switching operation at the negative side of
the battery.
Inspection:
Using the tester, measure the resistance between the
terminals.
Standard: 0.2 to 3.0 R
[Point 51
Installation:
Install the fuel pump to the tank cover.
Caution:
The hose connecting the main unit of the pump and the pipe
should be inserted thoroughly so that it will not lean to the one
side.