Toyota 4Y 2006 Manual page 78

Upper (on cylinder block side)
Front
Lower (on bearing cap side)
Note:
Store the caps, bearings and washers in correct order in order
to reinstall them in the same position as when they were
removed.
[Point 91
Inspection:
Measure the oil clearance of the crankshaft.
Do not turn the crankshaft during the measurement.
Standard: 0.02 to 0.051 mm (0.0008 to 0.0020 in.)
Limit: 0.10 mm (0.0039 in.)
If it exceeds the limit, replace the bearing. Or, if necessary,
replace the crankshaft.
Note:
When using STD bearings, replace with a bearing with the
same reference number (1 to 3) as that punched into the
cylinder block.
Inspection:
Inspect the bending of the crankshaft.
Inspect the bending when turning the crankshaft once.
Bending
=
runout of the dial gauge12
Limit: 0.06 mm (0.0024 in.)