Table of Contents
Advertisement
Configuring the POCKET ISDN-TA
X
Reduces the number of result messages after trying to set up a connection
ATX0 "CONNECT" only (without line speed)
ATX1 "CONNECT" with line speed, "BUSY", "NO DIALTONE" not used
ATX2 "CONNECT" with line speed, "BUSY" not used
ATX3 "CONNECT" with line speed, "NO DIALTONE" not used
ATX4 "CONNECT" with line speed, all messages used (default).
Z
The active configuration will be reset to the stored configuration.
Must be the last command in an AT command line.
ATZ
&Z
Stores dialing number nn as entry number x into the telephone list (x = 1..3).
AT&Zx=nn
set entry number x to dialling number nn
AT&Zx=-
erases entry number x.
AT&Zx shows entries number x.
AT&Z
show all entries.
Note: Refer to TA+Configurator command catab for more information.
See command ATDS for using.
#Z
Defines the msn nn (multiple subscriber number) for the data port.
If the number is set to "*" (default), all incoming calls are acceptable.
The msn can be displayed by command AT#H or AT&V.
AT#Z=nn
set msn to nn
AT#Z
shows currently set msn number.
The msn is automatically stored to non volatile ram (without issuing command
AT&W).
Note: If 1TR6 D channel protocol is selected, only one or the last digit is valid.
Reduce result messages
Load stored settings
Store call-number
Define own msn
19
Advertisement
Table of Contents
