Table of Contents
Advertisement
14
D
Dials the number (D for Dial). The dial modifier "W", ">", "T", ";", "@" can be freely
inserted in the dial string; they have no influence on the dial procedure of the TA.
Must be the last command in AT command line.
Any character input while the POCKET ISDN-TA is dialing will cancel the dialing
procedure.
ATD<CALLEDnumber>[/<subaddr>][//<UUS1data>]
[,X[Pxxx-][R ][N<nuipwd> ][G<cug> ]<X25number>][D<userdata>]]
CALLEDnumber: ISDN call number for a dialled B channel connection or
subaddr
dialled subaddress
UUS1data
transmitted data with UUS1 signalling
P :
use packetsize xxx for X.25 connection
R :
request the facility reverse charging
G :
access to X.25 closed user group
O :
Outgoing call from X.25 closed user group
N :
use NUI and password with call setup
allowed chars: a-z, A-Z, 0-9.
(overrides setting of nui configuration command)
X25number: dialled X.25 call number (X.25 B channel only)
D :
separator for userdata: "D" or ",": user data without protocol ID
ATDL
Dial the last dialled number
ATDS=n
Dial number n from stored telephone number list (n = 1..3)
(See command AT&Z to store numbers)
ATD<CALLEDnumber>e Make a call for remote management (see note).
Note1:
To setup the own subaddress see configuration command sub.
Note1:
Adding an "e" to CALLEDnumber indicates that a connection to the
internal remote access of a POCKET ISDN-TA shall be performed, the
protocol X.75 (ATB10) has to be used.
Initiate outgoing call
X.25 number for X.31 D channel
"P": user data with protocol ID ("01000000")
Operating manual Pocket ISDN-TA
Advertisement
Table of Contents
