Olympia 5991 - Door/Window Contact Manual

Introduction

Read the operating manual thoroughly and observe the information.
Keep the operating manual close by for future reference.

Information on the Door/Window Contact

• The door/window contact is designed for private use, indoors.
• The door/window contact only works in combination with an alarm system from the SECURE series.
• The door/window contact must be installed within transmission range of the base unit of the SECURE series alarm system.

Safety Instructions

The following safety information applies to the entire document. Read and observe all the warning information to protect yourself and the environment from any harm.

This device can be used by children from the age of 8 and persons with restricted physical, sensory or mental capabilities or a lack of experience and knowledge as long as they are supervised or have been instructed with regard to safe use of the device and are aware of the potential risks involved with its use. Children must never play with the device. Cleaning and user maintenance may not be completed by children without any supervision.

NEVER complete any repairs to the device yourself. Contact our Service department. The device does not contain any parts which the user needs to repair or service.

Risk of suff ocation! Children can swallow small parts, packaging and protective foils. Keep the device and packaging out of reach of children.

Risk of property damage through the use of inappropriate batteries! The use of inappropriate batteries can cause a loss of function of the device. Only use batteries of the type described in Section Technical Data.

Risk of property damage through environmental infl uences! Prevent environmental infl uences such as exposure to smoke, dust, vibration, chemicals, moisture, heat and direct sunlight.

Before starting to position the sensors, take into account that walls, ceilings and sources of electrical disturbance can impair wireless communication.

Intended Use

The door/window contact serves to monitor the position of doors and windows.
A condition for complying with the intended use is that the equipment is installed correctly and the information in the manual is observed and maintained. Any other use is considered unintended use.

Scope of Delivery

Please check the contents of the package carefully. If anything is missing or has been damaged during transport, DO NOT put the door/window contact into operation!

General View

The illustration at the beginning depicts the door/window contact in detail.

Installation

Before starting to position the sensors, take into account that walls, ceilings and sources of electrical disturbance can impair wireless communication.

Use the assembly material supplied (e.g. to compensate for height differences).
Pay attention that the surfaces to be adhered to are free of dust and grease.

1. Assemble the door/window contact on a window or door to be monitored as illustrated.
2. Pay attention that the distance between the magnetic contact and transmitter is maximally 5 mm when the window/ door is closed.

Inserting the Batteries

1. Open the battery compartment by pressing the locking latch downwards.
2. Replace to old batteries with new ones. Pay attention that the new batteries are inserted the right way around.
   
   
3. Close the battery compartment and tighten the screw using an appropriate screwdriver.

Registering a Sensor

You must register the door/window contact on the base unit. When the door/window contact is triggered, it sends a signal to the base unit and the base unit alarm sounds.

1. Press and hold the corresponding button on the base unit to register sensors.
2. Trigger the door/window contact, e.g. by opening the window or door being monitored.

Technical Data

Information on Disposal

The adjacent symbol indicates that electrical and electronic apparatus and batteries no longer required must be disposed of separate from domestic waste in accordance with legal directives.

You are legally obliged to dispose of batteries and battery packs at shops which sell batteries or collection points which provide the corresponding containers. Disposal is free of charge. The symbols indicate that the batteries must not be disposed of in normal domestic waste and that they must be brought to collection points provided by local public waste authorities.

Packaging materials must be disposed of according to local regulations.

Guarantee

Dear Customer, we are pleased that you have chosen this equipment.
In the case of a defect, please return the device together with the receipt and original packing material to the point-of-sale.

Cleaning and Service

1. Clean the surface of the housing with a soft, lint-free cloth. Never use any chemicals or scouring agents.
2. Check the functionality of each sensor registered once a month and after changing the batteries.
3. Change the batteries at least once a year or after receiving the relevant message from the alarm system.

Information on Conformity

Olympia Business Systems Vertriebs GmbH, Zum Kraftwerk 1, 45527 Hattingen hereby declares that this device fulfi ls the basic requirements and other relevant provisions stipulated in the Directive 2014/53/ EC. The CE mark on the device confi rms its conformity.

More detailed information on the Declaration of Conformity is provided at http://productip.com/?f=6f1ed or scan this QR code.