Advertisement
Overview
1.3
ACPI Suspend to Hard Drive
For a detailed installation procedure please refer to the following procedure to
enable ACPI Suspend to Hard Drive on the AOpen AX6BC EZ motherboard.
First please check if your system meets the following requirements, then follow
the procedure step by step.
System Requirement
1. AOZVHDD.EXE
1.30b
default.htm#Suspend to Hard Disk Drivers).
2. Delete config.sys and autoexec.bat.
I. Fresh installation
1. Execute "Setup.exe /p j" to install Windows 98.
2. After Windows 98's installation is completed, go to Control Panel --> Power
Management.
a. Set "Power Schemes -> System Standby" to "Never".
b. Click on "Hibernate" and select "Enable Hibernate Support" then "Apply".
c. Click on the "Advanced" tab, you'll see "Hibernate" on "Power Buttons".
Note that this option will only be seen after step b mentioned above has
been completed, otherwise only "Standby" and "Shutdown" will be shown.
Select "Hibernate" and "Apply".
3. Run AOZVHDD utility.
a. If you assign the whole disk to your Win 98 system (FAT 16 or FAT 32),
please run "aozvhdd /c /file" in DOS mode. Please remember sufficient
free space has to be reserved in the disk, e.g. if you have 64 MB DRAM
and 16 MB VGA card installed, the system needs at least 80 MB free
space. The utility will locate the space automatically.
b. If you assign an individual partition for Win 98, please run "aozvhdd /c
/partition". Of course, the system needs to provide unformatted an empty
partition.
4. Reboot system.
5. You've already implemented ACPI with Suspend-to-Harddisk. Click "Start ->
Shut Down -> Standby" then the screen will go off immediately. And 1
minute or so will be taken for the system to save what's in the memory to the
harddrive; the larger the memory size the longer this process will take.
1-8
or
later
(http://www.aopen.com.tw/tech/mbdrv/
Advertisement
