Advertisement
Power Management à AC PWR Auto Recovery
AC PWR Auto
A traditional ATX system should remain at power off
Recovey
stage when AC power resumes from power failure.
This design is inconvenient for a network server or
Former-Sts
workstation, without an UPS, that needs to keep
On
power-on. This item is used to solve this problem.
Off
Selecting On lets the system can automatically
power-on after AC power resumes; in the other hand,
the system will power-off if you select Off. If Former-
Sts option is selected, the system will power-on or
power-off based on the original state.
Integrated Peripherals à LED Flash As Power Saving
LED Flash As Power
This item is used to enable or disable the LED flash
Saving
while power saving mode.
Enabled
Disabled
Integrated Peripherals à Onboard FDC Controller
Onboard FDC
Setting this parameter to Enabled allows you to
Controller
connect your floppy disk drives to the onboard floppy
disk connector instead of a separate controller card.
Enabled
Change the setting to Disabled if you want to use a
Disabled
separate controller card.
Integrated Peripherals à Onboard Serial Port 1
Integrated Peripherals à Onboard Serial Port 2
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
This item allow you to assign address and interrupt
for the board serial port. Default is Auto.
AWARD BIOS
3-35
Advertisement
