C. Install the Cylinder Rotor Unit so that the inner hole of the
Cylinder Rotor Unit fits to the small projection (D) on top of the
Upper Cylinder.
D. Tighten 2 screws (B).
E. Install the Cylinder Stator Unit.
F. Tighten 2 screws (A).
G. Confirm the PG SHIFTER ADJUSTMENT with the alignment
tape (NTSC: VFM8080HQFP) and adjust it if necessary.
2.3.5. FLAT CARD CABLE INSTALLATION
Fig. S9
Fig. S10
13