Line Pressure Displays; Returning To Normal Mode - SAFEMATIC ST-1100i Manual

Configuration settings
Note
Table 1.
Time display code
SG1
SG2
SG2E
OS
Display pressure unit should be either bar or psi.
Pressure monitoring unit type can be either pressure switch (S) or pressure transmitter (P).

3.1.3 Line pressure displays

In pressure
Settings/Pressure button. Pressing the button will show the line 1 pressure display first.
Another press will show line 2 pressure display and if there is no line 2, program returns back to
display phase code. From line 2 pressure display program returns to display phase code by
pressing Settings/Pressure button.
The lines selected in pressure display are presented in the value display as codes P1 or P2.
The pressure in the selected line is displayed in time display.

3.1.4 Returning to normal mode

Program returns to display program phase code (normal or alarm mode) in the following cases
1. Settings/Pressure or arrow button was last pressed more than three minutes ago.
2. both arrow buttons are simultaneously pressed down for 3 seconds
3. -button is used to browse into phase code display
4. center is restarted
110i1CEN.doc
Configuration settings should be changed only in connection to system
changes. These changes are usually implemented by the supplier.
Configuration mode requires a password.
Center operation modes
Selected operation mode
single line grease lubrication system
dual line grease lubrication system
dual line grease lubrication system, pressure maintaining function
oil lubrication system
transmitter operation,
SAFEGREASE, SAFEOIL
ST-1100i
line pressure displays
6 (14)
can be selected with
16.04.2003 Rev. 1C