Entering Password; Setting Mode; Lubrication Cycle Counter - SAFEMATIC ST-1100i Manual

4.3 Entering password

Select code PASS at time display.
Enter correct password using Settings/Pressure and arrow buttons.
When Settings/Pressure button is released, the center goes into Setting mode. The codes
show now decimal points, for example C.C.
Note

4.4 Setting mode

Setting mode displays showing the lubrication program set values can be browsed by means of
arrow buttons.
Value display codes change in the following order when
when
One can leave Setting mode but browsing to code PASS by means of
Display code
C.C.
L.C.
L.P.
L.d.
L.o.
H.i.

4.4.1 Lubrication cycle counter

Code C.C. shows the lubrication cycle counter reading at display.
The counter can be reset by setting the counter value to zero using Settings/Pressure and
arrow buttons. The only changeable counter setting is to reset the counter.
110i1CEN.doc
Set value password is 2.
-button is pressed.
Description
Lubrication cycle counter
(Cycle Counter)
Lubrication cycle set value
(Lubrication Cycle)
Maximum pressurization set value
(Lubrication, Pressurization time)
Lubrication delay time coefficient
(Lubrication delay)
Code is used only in pressure switch operation
Low limit pressure set value
(Low limit pressure)
Code is used only in pressure transmitter operation
High limit pressure set value
(High limit pressure)
Code is used only in pressure transmitter operation
SAFEGREASE, SAFEOIL
ST-1100i
-button is pressed and vice versa,
11 (14)
-button.
16.04.2003 Rev. 1C