Table of Contents
Advertisement
2.2 Control Panel
2.2.1 General
Control panel is located inside the casing. Control panel has a 6-character display, three
buttons and the input/output LED signals. The display and buttons can be used for setting the
default values for lubrication program and for turning on manual control.
2.2.2 Display
The control panel has a 6-character 7-segment display.
The display has been divided into two groups
•
2-character value display gives the phase or value code
•
4-character time display gives the value corresponding to the code
Time display
When time display is showing a time value, the decimal point blinks at intervals of 5 seconds.
Regardless of the code, time is always displayed the same way and as accurately as possible.
Time displayed
0 s – 99 min 59 s
100 s -999 min 59 s
1000 min – 999 min
> 9999 min
2.2.3 Buttons
Button
Setting/Pressure
110i1CEN.doc
SAFEGREASE, SAFEOIL
ST-1100i
Display format
MM.SS
MMM.S
MMMM.
9999.
Description
In Setting mode and while entering the password, button can be used to
change the displayed value with arrow keys.
Button can be used to accept transferring into manual operation, if the
value at the display is the code for manual operation. In manual
operation mode, pushing the button runs the function selected at display.
In pressure transmitter use, button can be used for browsing the
pressurized line pressure readings in normal and manual operation
modes.
Button can be used for scrolling the next display below.
In Setting mode and entering password, button can be used for
decreasing the displayed value, if the Setting/Pressure button is
pressed down.
Button can be used for scrolling the next display above.
In Setting mode and entering password, button can be used for
increasing the displayed value, if the Setting/Pressure button is pressed
down.
Example
12 min 34 s = 12.34
123 min 45 s = 123.4
1234 min = 1234.
12345 min = 9999.
2 (14)
16.04.2003 Rev. 1C
Advertisement
Table of Contents
