Operation - Kreg PRS1000 Owner's Manual

Operation

1
Adjust Edge Posts
a. To accommodate for material width,
position the edge stop posts (C) into the
different threaded holes on the underside
of the base plate (A). Material must be 3
1/2" wide or greater for use and material
thickness should be a minimum of 1/2"
thick.
b. Adjust the edge stop posts (C) so that all
four posts contact the material edge and
tighten snugly by hand.
2
Trim Router or Full Sized Router
a. Install the Kreg Flush-Trim Bit - 1/4" Shank (PRS250) into the router. (Refer to the power tool
owner's manual for installation.)
b. Adjust the router bit height to the thickness of your material. The bearing on the shank
should be positioned so it rides against the base plate (A).
c. Position the handle away from yourself and the edge facing toward you.
d. Ensure that the base plate (A) is positioned securely to the material by clamping it in place or
firmly applying enough down pressure on the handle.
e. Place router so its base rests on top of the profile template. Be sure that the bit is
not in contact with material before powering up the trim router. Run the trim router
counterclockwise (left to right) along the material. For cuts larger than half of bit diameter
(1/2"), make multiple passes, running the router from left to right, and taking off only a small
amount of material. The bit bearing will not contact the template until the last pass.
f. For full sized routers, follow the same steps but use the Kreg Flush-Trim Bit - 1/2" Shank
(PRS500).
5