Troubleshooting Aid - FeinTech FLR00100 Instructions Manual

Troubleshooting aid

Problem
Air purifier does not switch
on
Air purifier does not respond
to button
Air purifier makes unusual
noise
Significantly reduced air
output
Poor air purification
Filter indicator still on after
filter change
Air purifier switches off au-
tomatically without a timer
being active
Air purifier beeps several
times after switching on and
does not run
Cause
Mains plug not plugged in
Power button not pressed
Power socket is de-energised
Air cleaner defective
Plug or cable damaged
LOCK activated (LOCK flashes)
Unit or socket is de-energised
Air purifier defective
Filter is dirty
Filter is not inserted correctly
Filter is still packed
Foreign body has penetrated
Filter is dirty
Filter is still packed
Too little air inlet
Filter not inserted correctly or dirty
Space too large
Air inlet or outlet is blocked
Filter indicator has not been reset
correctly
Air cleaner is defective
Solution
Plug in the mains plug
Press the power button.
Check the fuse and the switch for the socket
used.
Carefully disconnect the air purifier from the
power supply. Do not use the unit any more.
Contact your salesperson or FeinTech.
Press LOCK for 3 seconds.
Check the fuse and switch for the socket in use
and that the power cord is plugged in.
Carefully disconnect the air purifier from the po-
wer supply. Do not use the appliance any more.
Contact your salesperson or FeinTech.
Please clean or replace the filter.
Insert the filter correctly
Remove the filter packaging before use
Carefully disconnect the air purifier from the
power supply. Do not use the unit any more.
Contact your salesperson or FeinTech.
Please clean or replace the filter.
Remove the filter packaging before use
Ensure sufficient distance of approx. 30 cm to
all sides
Make sure the filter is correctly seated
Use the air purifier in a smaller room
Make sure there are no openings
Reset the filter indicator again (see p. 5).
Carefully disconnect the air purifier from the
power supply. Do not use the unit any more.
Contact your salesperson or FeinTech.