Use Of The Appliance - FeinTech FLR00100 Instructions Manual

Use of the appliance

Insert the plug into the socket. All the lights come on for 1 second and you hear a beep, then all the lights stay OFF. Press
the on-off button  to switch on the unit. The AQ light turns on and the fan rotates at a speed of level 2 (medium).
Setting the fan speed
The current fan speed is shown on the speed display. Press the speed button  to set the fan speed. Levels 1–4 of the
display  correspond to Low, Medium, High and Turbo.
Sleep mode
When you use the unit in sleep mode, it operates very quietly. Only the and keys  and  (if you set the timer) are at half
brightness, all other keys are not lit. Press any other key to exit the sleep mode.
Air Quality Sensor Light (AQ Light)
Inside the air purifier is an air quality sensor. The air quality (AQ, Air-Quality) is indicated by a different light colour. The light
colour changes depending on the air quality detected:
RED = POLLUTED
ORANGE = POOR
GREEN = GOOD
BLUE = VERY GOOD
With the air purifier switched on, press the button
types of light: constant or pulsating. The difference is only visual. To switch between constant and pulsating display mode,
press the button for 3 seconds.
Note: The sensor does not replace a professional measuring instrument, but allows simple control based on rough read-
ings.
Auto mode
Tap AUTO to switch sensor-controlled operation on or off. In Auto mode, the fan speed is automatically set according to the
AQ level as follows:
AQ-colour
Air quality
Fan speed
Blue
very good
1 (low)
once briefly to switch the AQ light on or off. The AQ indicator has two
Green
good
2 (medium)
1. On/Off button
2. fan speed
3. speed display
4. filter reset
5. AQ / night light
6. auto mode
7. sleep mode
8. lock
9. timer display
10. timer setting
Orange
bad
3 (high)
Red
polluted
4 (turbo)