FeinTech FLR00100 Instructions Manual page 13

Night light mode (only when the unit is in standby).
The air purifier has a night light for discreet illumination. This lights up when you press the button
night light is adjustable in 2 brightness levels and in orange or white light colour. Press the button
on the night light. The brightness and light colour change each time you press
Set timer
Press this button to switch the timer on or off and to cycle through the timer options (2 hours, 4 hours, 6 hours or 8 hours).
The air purifier will automatically switch off when the timer has expired.
NOTE: When you switch off the air purifier, the timer is deactivated immediately.
Control lock
Press the Lock button to activate the control lock. This lock is useful, for example, in households with small children. Press
the Lock key again for 3 seconds to deactivate the lock.
Filter change light
When the indicator
filter should be replaced after about 6 months.
Note: The life of the filter depends on the air quality in your home and the amount of time you use it. If you use the unit
in a humid or very dusty environment, the life of the filter will be reduced. Please also replace the filter if you notice the
following signs:
• Increased operating noise
• Reduced airflow
• Clogged filter
• Increased occurrence of odours
Cleaning the filter
To prolong the life of the filter, you can clean the outside of the filter (pre-filter). To do this, vacuum off e.g. coarse dirt such
as dust or animal hair with a hoover. Please limit the cleaning to the outside of the filter and do not use water or cleaning
agents! Please proceed carefully and do not press the filter in.
Resetting the display after changing the filter
To change the filter, please disconnect the mains plug. Then proceed as described on page 6. Then reset the filter indicator
. Depending on whether the indicator is already lit or not, please proceed as follows:
If the filter indicator
• Plug in the mains plug and switch on the air purifier.
• Press the button for 3 seconds. The indicator then goes out and the filter has been reset.
If you change the filter without the filter indicator
• Plug in the mains plug and switch on the air purifier.
• Press the button
• Press the button
is lit, you should check the filter to see if it needs cleaning or replacement. With typical use, the
is lit, please reset the indicator as follows:
for 3 seconds until the indicator lights up.
again for 3 seconds. The display then goes out and the filter has been reset.
lighting up, please reset the indicator as follows:
in standby mode. The
in standby to switch
.