Changing The Filter - FeinTech FLR00100 Instructions Manual

Changing the filter

Switch off the air purifier and disconnect the mains plug.
Then place the air purifier on a soft surface,
so that the surface is not scratched.
Then turn the foot of the housing anticlockwise to open the housing.
to open the housing. The arrow indicator will change from LOCK to OPEN.
Then pull off the housing foot and remove the old filter.
Take a new filter out of its packaging. Insert the filter into the housing.
Make sure that the filter is correctly seated and close the housing.
To do this, turn the housing foot clockwise until it „clicks".
The arrow indicator now points to LOCK and the housing is closed.
Then set up the air purifier. Plug in the mains plug and switch on the unit.
Then reset the filter indicator as described above.