Advertisement

Quick Links

BEFORE YOU BEGIN
Warning read instructions carefully
before use.
Recommended procedure to follow in
this document.
For safety reasons it is recommended
that at least two persons set up any
Marquee.
Ensure area is free from any sharp
objects & overhead objects.
WARNING: Keep clear of
overhead power lines.
SIZES: 3m x 3m, 3m x 4.5m and 3m x 6m
CONTENTS
TRANSPORTING
THINGS YOU SHOULD KNOW
Your marquee is supplied with steel pins and
tie-down ropes. These MUST all be used. For
setup on hard surfaces such as pavement,
weight plates, water weights or sandbags
MUST be used for security.
These are add-on accessories that can be
purchased separately.
All roof tie-down straps MUST be attached
and tensioned. These security methods
will maximise safety. However, due to the
unpredictable nature of weather, damage
prevention is not guaranteed.
All folding marquees are considered temporary
structures and MUST be packed down and
stowed away in any adverse weather conditions
such as storm, rain or wind gusts. Your marquee
should never be left up unattended.
Prolonged exposure to the sun can seriously
degrade the material and/or cause it to
become discoloured.
1
1
1
1
1
WARNING: KEEP ALL FLAME
AND HEAT SOURCES AWAY
FROM THE TENT FABRIC.
This marquee is built with flame
retardant. The fabric may burn if left
in continuous contact with any flame
source. The application of any foreign
substance to the marquee fabric may
render the flame-resistant properties
ineffective.
THIS PRODUCT MEETS AUSTRALIAN
STANDARDS
Please check with your local
regulations prior to purchasing this
item. Some municipalities have
restrictions and requirements.
2
3
4
5
10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Q8 QUASAR and is the answer not in the manual?

Questions and answers

Summary of Contents for Extreme marquees Q8 QUASAR

  • Page 1: Table Of Contents

    BEFORE YOU BEGIN THINGS YOU SHOULD KNOW WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY Warning read instructions carefully Your marquee is supplied with steel pins and FROM THE TENT FABRIC. before use. tie-down ropes. These MUST all be used. For setup on hard surfaces such as pavement, This marquee is built with flame Recommended procedure to follow in...
  • Page 2: What You'll Need

    WHAT YOU’LL NEED Stanley Knife / Scissors to open boxes. Only cut where symbol is shown on boxes. Mallet / Hammer to secure steel pins. PARTS LIST Standard package items listed below. Please note accessories are not listed here. 1x Protective Cover 1x Marquee Frame 1x Marquee Roof 8 x Pins...
  • Page 3: Set- Up Instructions

    SET- UP INSTRUCTIONS Please read instructions completely before setting up your marquee. Make sure you have all the parts identified on the Parts List. Recommended procedure below. For safety reasons it is recommended that 2 persons set-up / pack down any marquee. 1.
  • Page 4: Pack Down Instructions

    3MX6M SET- UP INSTRUCTIONS Recommended procedure below. For safety reasons it is recommended that 2 persons set-up any marquee. 9. Middle Legs. 10. Ensure protective flap is over the connector. Attach roof straps by looping straps around frame and engaging clip. Lift the front back roof connectors until pin locks into position.
  • Page 5: Protective Cover

    6 legs are lowered. WHEELED PROTECTIVE COVER Q8 Quasar Range includes a Wheeled protective cover bag for sizes 3x3m, 3x4.5m and 3x6m frames. MOVING WHEELED PROTECTIVE COVER 1. Ensure the protective cover is correctly secured over the Marquee.
  • Page 6: Optional Accessories Instructions

    OPTIONAL ACCESSORIES INSTRUCTIONS Q8 FULL WALL INSTRUCTIONS Recommended procedure below. For safety reasons it is recommended that 2 persons pack down any tent. 1. Unzip the Left and Right Wall Strips on the 3. Insert the top of the Wall Strip Keda into the 2.
  • Page 7 Q8 HALF WALL INSTRUCTIONS Recommended procedure below. For safety reasons it is recommended that 2 persons pack down any tent. 1. Unzip the Left and Right Wall Strips on the 2. Slide the Leg Rubber Inserts (2) along the 3. Insert the top section of the of the Wall Strip Half Wall Panel.
  • Page 8 WHEELED MARQUEE - ATTACHING WHEELS 1. On a bench or on the ground lay marquee 2. Locate ‘dimples’ on foot plate, position 3. Tighten the wing nuts on the left/right until on side, extend inner leg of marquee. the wheel on foot plate so wing nuts and finger tight.
  • Page 9 BANNER INSTRUCTIONS 1. Layout banner fabric, three stage banner 2. Small Banners / 2m pole, banner tip pole and protective cover. Extend the banner pole to the designated line 2m line and twist and keep twisting the pole to secure. 3.
  • Page 10: Important Information

    As such, fault for reason other than above, please complete our Extreme Marquees does not accept liability for any missed warranty claim form - www.extrememarquees.com.nz/ due date nor do we accept any refund request based on this resource-centre/ and email it through to - logistics@ premise.
  • Page 11 RETURNING ITEMS We recommend that the roof of your marquee should be Before returning any part or product to Extreme Marquees please contact us to obtain specific return shipping cleaned regularly depending on frequency of use. instructions logistics@extrememarquees.co.nz or call us on Allow your marquee to completely dry before packing down 0800 424 313.

Table of Contents