Extreme marquees EMX Beta Series Inflatable Instructions

WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
EMX Alpha / Beta / Delta / Gamma / Omega Ranges
Recommended procedure below. For safety reasons it is recommended that 2 persons set up any marquee.
ONE
Remove Inflatable Marquee from
Protective Cover.
FOUR
Marquee Accessories*
Layout your Walls and Awnings and
confirm positioning.
SEVEN
Connect the pump to selected Inflation
Valve and begin inflation.
TEN
Fix Steel Pins and Guide Ropes or
attach Sandbags.
We design | We manufacture | We sell
INFLATABLE INSTRUCTIONS

SETUP - INFLATION

Ensure area is free from any sharp objects & overhead objects.
TWO
Roll out the marquee.
FIVE
Attach the accessories using zips.
EIGHT
During the inflation process raise legs
into the center until all legs are upright.

IMPORTANT NOTES:

Check the wind and weather
conditions before commencing
construction.
Ensure you have the correct ground
fixings for your application.
When the marquee is in use, do not
leave your marquee unattended.
| We Deliver Australia wide
www.extrememarquees.com.au
THREE
Lay the Inflatable Marquee out flat.
SIX
Each leg on the marquee has a valve. Select
valve to attach pump, screw inflatation value
closed and leave cap off.
On all other valves screw tight and fix cap.
NINE
Ensure all legs are lined up and roof
is centered. Check frame is firm.
Over pressure relief valve system,
DO NOT TOUCH.
admin@extrememarquees.com.au
1300 850 832