Yeti SB160 Owner's Manual page 10

13
Install Female 8x45mm Bolt (3.18) with Washer
(3.21) through front Shock Eyelet and secure with
M6 Male Bolt (3.19) and Washer (3.20).
Torque: 10 Nm
14
Install Housing Clamp Cap (3.8) onto the drive-
side main pivot axle with a M4 x 16L FHCS (3.25)
Tighten until snug. Hardware can be torqued to
2-3 Nm after housing installation.
15
Install a Housing Clamp Cap (3.8) and Clamp
Base (3.6) onto the non-drive main pivot wedge
bolt with a M4 x 25L FHCS (3.26).
Tighten until snug. Hardware can be torqued to
2-3 Nm after housing installation.
SB160 | OWNER'S MANUAL
16
Install Univesal Hanger (3.34) into frame.
Do not use grease. Note that hanger cap
bolt is reverse threaded.
Torque: 25 Nm
10