Black & Decker REVHV8C Manual page 7

Labels on appliance
The following symbols appear on this ap-
pliance along with the date code.
Read all of this manual care-
fully before using the appli-
ance
Only use with charger
GB:S010QB1400040
GB:S010QB1400040
QW:S010QV1400040
QW:S010QV1400040
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Main handle
3. Charge indicator LED
4. Filter assembly
5. Dust bowl
6. Flip down brush
7. Charger
8. Crevice tool (Only available with REVHV8CA)
Operation (Fig. A)
To turn on slide the On/Off switch (1) forward as shown in
u
figure A.
Slide the On/Off switch backward, the appliance stops
u
working.
Using the flip down brush (Fig. B)
Flip the brush into position for use, as shown in figure B.
u
Attaching Accessories (Fig. C
If you need to use an accessory such as the crevice tool
u
(8) (supplied with European unit only) insert the accessory
into the air inlet as shown in figure c and then start the
appliance.
Charging (Fig. D)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Insert the charger jack plug (7) into the charging port (9).
u
Plug in the charger. Switch on at the mains.
u
The LED (3) indicator wiil light up while charging and
u
switch off when fully charged.
While charging, the charger may become warm. This is
u
normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
(Original instructions)
Cleaning the filters (Fig. E, G, H)
Rotate the dust bowl (5) in a counterclockwise direction to
u
release from the appliance body as shown in figure E.
Take out the filter assembly (4) from the dust bowl (5).
u
The prefilter (4a) and filter (4b) can be seperated and
u
rinsed with water and should be dried afterwards.
Dispose of the dirt inside the dust bowl as shown in figure
u
H. The dust bowl can be rinsed by water.
However it needs to be dried afterwards.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Note:
BLACK+DECKER's policy is one of continuous
u
improvement to our products and, as such, we reserve the
right to change product specifications without prior notice.
Standard equipment and accessories may vary by coun-
u
try.
Product specifications may differ by country.
u
ENGLISH
7