Replacing A Broken Return Spring; Starter Assembly - Husqvarna 555 Workshop Manual

7.4 Replacing a broken return spring

WARNING!
Exercise care to ensure the spring
does not fly out and cause person-
al injury. Wear protective goggles.
1
Loosen the screw at the centre of the starter pulley
and loosen the screws on the cassette. Remo e
the starter pulley with the cassette and spring.
2
Remo e the broken cassette and replace it with a
new one.
3
Tighten the screw at the centre of the starter pulley,
at a tightening torque of 2-3 Nm. Load the return
spring, see Loading the return spring . See also
the ismantling the starter chapter.

7.5 Starter assembly

1
Position the starter against the crankcase and
tighten the screws at a tightening torque of
3-4 Nm.
Repair nstructions
27
English -