Loading The Return Spring; Replacing A Broken Return Spring; Assembling The Starter - Husqvarna T425 Workshop Manual

7.3 Loading the return spring

1
Wind approx. 3 turns of the starter cord onto the
pulley. Fit the bolt into the centre of the starter pul-
ley, tightening torque 2-3 Nm. Pull the starter cord
up into the notch in the starter pulley and turn the
pulley about 3 turns clockwise.
2
Stretch the cord with the handle. Remove your
thumb and let the cord spin back. Check that the
pulley can be turned at least a further 1/2 turn
when the starter cord is pulled all the way out.

7.4 Replacing a broken return spring

WARNING!
Exercise care to ensure the spring
does not fl y out and causes person-
al injury. Wear protective goggles.
1
Undo the screw in the centre of the pulley and
remove the pulley and spring.
2
Remove the broken return spring and replace it
with a new one.
3
Fit the bolt into the centre of the starter pulley,
tightening torque 2,5 Nm. Load the return spring,
see "Loading the return spring".

7.5 Assembling the starter

1
When assembling the starter, ensure that the rubber
bellows is inserted into the carburetor area (see
fi gure 9).
Fig 7
Fig 8
Fig 9
Repair instructions
29
English -