Getting Started; Turn Off The Printer; Troubleshooting - Lexmark Optra T522 Setup Manual

Getting started

137.16 cm
(4.5 ft)
304.8 mm
(12 in.)
508 mm
(20 in.)
Printer
Handhold
Power
switch
cover
500 sheet drawer
304.8 mm
(12 in.)
304.8 mm
(12 in.)
Operator panel
overlay
Power cord
(non-English only)

Turn off the printer

Options compatibility

Troubleshooting

1
Select a well-ventilated place to set up your
printer. Allow at least as much space as
shown in the illustration. Make sure you
have a sturdy, low table or the optional
printer stand on which to set the printer.
2
Remove all items from the box except the
printer. If any items are missing, contact the
CDs
place where you bought the printer.
Save the carton and packing material in
case you need to repack the printer for ser-
Paper bail
and bracket
vice or storage.
Note: Leave the printer in the box until you are
ready to install it. Then ask someone to
help you lift the printer using the hand-
holds.
If your printer is already set up, make sure the
printer power is off and the power cord and any
cables are unplugged before installing any
options.
Options compatible with the Lexmark T522
printer are labeled with a colored triangle. Label
locations are indicated in the illustrations in this
book.
If you encounter a problem while setting up the
printer, refer to the Lexmark T522 Publications
CD.
TM
1