Reattaching The Shield And Closing The Doors - Lexmark Optra T522 Setup Manual

Reattaching the shield and
Tabs
16
closing the doors
After you have installed option cards on the printer system
board, follow these steps to reattach the shield and close
the doors.
1
Grasp the shield by the tabs and align the three key-
holes on the shield with the top three screws. Hold-
ing the shield by the tabs, slide it down onto the
screws. Tighten all six screws.
2
Close the side door.
3
Close the upper and lower front doors.
Note: If you have not completed the section "Setting
up the printer" beginning on page 6, do so now.