Power Backup Operation - Panasonic KX-TG3833 Operating Instructions Manual

2
MbN: Select the desired unit or "Voice
paging". a MSELECTN
R If you select "Voice paging", speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit
handsets, until a paged party answers
your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press MOFFN.
*1 KX-TGE640 series: page 3
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
Base unit *1
*1 KX-TGE640 series: page 3
1
Press MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2
When you finish talking, press MZN.
Answering an intercom call
Handset
1
Press M N to answer the page.
2
When you finish talking, press MOFFN.
*1
Base unit
*1 KX-TGE640 series: page 3
1
Press MZN to answer the page.
2
When you finish talking, press MZN.
Turning auto intercom on/off
Handset / Base unit
*1 KX-TGE640 series: page 3
For assistance, please visit http://shop.panasonic.com/support
KX-TGE63x_64xUSA_(en)_1213_ver031.pdf 21
*1
and all
*1
Making/Answering Calls
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press M
MZN. When this feature is set to "On", the
monitoring handset or base unit for the baby
monitor feature (page 40) will also answer
baby monitor calls automatically. The default
setting is "Off".
1
For handset setting: MMENUN#273
For base unit setting (using a
*1
handset) : MMENUN#*273
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.

Power backup operation

When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. However, some
functions such as Caller ID and phonebook
are available only when using a handset other
than the handset supplying power to the base
unit. You can program "Power failure"
and the default setting is "Auto" (page 36).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Power
outage Press OFF" is displayed. After
pressing MOFFN on the handset, place it on
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
handset is or .
R Do not lift the power supplying handset
from the base unit during power backup
mode.
N or
21
13/12/2017 4:29:17 PM