Table of Contents
Advertisement
Making/Answering Calls
2
Wait for the paged party to answer.
R If the paged party does not answer,
press M
N to return to the outside call.
3
To complete the transfer:
Press M
N.
To establish a conference call:
M
N a MbN: "Conference" a MOKN
R To leave the conference, press M
The other 2 parties can continue the
conversation.
R To put the outside call on hold: M
a MbN: "Hold" a MOKN
To resume the conference: M
MbN: "Conference" a MOKN
R To cancel the conference: M
MbN: "Stop Conference" a MOKN
You can continue the conversation
with the outside caller.
Intercom
Available for:
KX-TGD312/KX-TGD322
Intercom calls can be made between handsets
in the same radio cell.
Note:
R When paging the handset, the paged
handset beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds.
To finish intercom, press M
the call, press M
Making an intercom call
1
M
N
When 3 or more handsets are
registered:
MbN: Select the desired unit. a MOKN
2
When you finish talking, press M
Answering an intercom call
1
Press M
N to answer the page.
18
N a
N a
N. To answer
N.
N.
2
When you finish talking, press M
Turning auto intercom on/off
This feature allows the handset to answer
intercom calls automatically when it is called.
You do not need to press M
feature is set to "On", the monitoring handset
N.
for the baby monitor feature (page 33) will
also answer baby monitor calls automatically.
The default setting is "Off".
N
1
M
N#273
2
MbN: Select the desired setting. a MOKN
a M
Key lock
The handset can be locked so that no calls or
settings can be made. Incoming calls can be
answered, but all other functions are disabled
while key lock is on.
To turn key lock on, press M
seconds.
R To turn key lock off, press M
3 seconds.
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
Power backup operation
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 27).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press
pressing M
the base unit to start power backup mode.
N. When this
N
N for about 3
" is displayed. After
N on the handset, place it on
N.
N for about
Advertisement
Table of Contents
