Power Backup Operation - Panasonic KX-TGF743 Operating Instructions Manual

Making/Answering Calls
Making an intercom call
Handset
1
MMENUN a MbN: "Intercom" a
MSELECTN
2
MbN: Select the desired unit or "Voice
paging". a MSELECTN
R If you select "Voice paging", speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit and all
handsets, until a paged party answers
your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press MOFFN.
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
Base unit
1
Press MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2
When you finish talking, press MZN.
Answering an intercom call
Handset
1
Press M N to answer the page.
2
When you finish talking, press MOFFN.
Base unit
1
Press MZN to answer the page.
2
When you finish talking, press MZN.
For assistance, please visit http://shop.panasonic.com/support
20
TGF74xUSA_OI_0416_ver211.pdf 20
Turning auto intercom on/off
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press M
MZN. When this feature is set to "On", the
monitoring handset or base unit for the baby
monitor feature (page 45) will also answer
baby monitor calls automatically. The default
setting is "Off".
Handset / Base unit
1
MMENUN#273
2
MbN: Select the desired setting. a
MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.

Power backup operation

When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. However, some
functions such as Caller ID and phonebook
are available only when using a handset other
than the handset supplying power to the base
unit. You can program "Power failure"
and the default setting is "Auto" (page 38).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Power
outage Press OFF" is displayed. After
pressing MOFFN on the handset, place it on
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
handset is or .
N or
2020/04/16 8:51:25