Table of Contents
Advertisement
Note:
R When paging the handset, the paged
handset beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds.
To finish intercom, press M
the call, press M
N.
Making an intercom call
1
M
N
2
When you finish talking, press M
Answering an intercom call
1
Press M
N to answer the page.
2
When you finish talking, press M
Key lock
The handset can be locked so that no calls or
settings can be made. Incoming calls can be
answered, but all other functions are disabled
while key lock is on.
To turn key lock on, press M
seconds.
R To turn key lock off, press M
3 seconds.
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
Power backup operation
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 20).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
0906_TGC41xCX (en)_ver002.pdf 15
power Press
pressing M
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
N. To answer
handset is
R Do not lift the power supplying handset
from the base unit during power backup
mode.
Panasonic Ni-MH battery
N.
performance (supplied batteries)
during power backup mode
When the batteries are fully charged,
operating time of the handset in power backup
mode varies depending on usage.
– Continuous use of the handset in power
N.
backup mode: 2 hours max.
– Continuous use of the handset other than a
handset in power backup mode: 3 hours
max.
– Not in use in power backup mode: 3 hours
max.
Making calls during a power
failure
N for about 3
n When only 1 handset is registered:
N for about
1
2
3
4
n When 2 or more handsets are registered:
You should leave one handset on the base
unit for supplying power, and use another
handset for making calls.
Note:
R The range of the base unit is limited during
a power failure. Please use the handset
close to the base unit.
Making/Answering Calls
" is displayed. After
N on the handset, place it on
/
.
Lift the handset and dial the phone
number.
Within 1 minute, place the handset on
the base unit.
R Wait until speakerphone is turned
on automatically and the call is
made.
When the other party answers the call,
keep the handset on the base unit and
talk using the speakerphone.
When you finish talking, press M
6/9/2016 3:19:58 PM
N.
15
Advertisement
Table of Contents
