Initializing The Temp Map - ADTRAN TSU 610 User Manual

Chapter 4. T1 Network Interface
4-18
Normally, map configuration involves these steps.
Step
1 Initializes the Temp Map to one of three config-
urations (current Map A, current Map B, or all
IDLEs). This step is optional.
2 Edits the Temp Map so that it reflects the desired
map configuration.
Replaces the current DS0 map A or B configura-
3
tion with the Temp Map configuration.

Initializing the Temp Map

Upon entering the DS0 maps configuration menu, the Temp
Map reflects its last configured state. You can then use the
following selections.
Use selections...
1, 2, 3
1, 2
3
TSU 610 User Manual
Action
To initialize...
the displayed Temp Map to one of
three configurations.
the Temp Map from its current con-
figuration to one which reflects the
currently stored Map A or B configu-
rations, respectively.
the Temp Map to an all IDLE state.
61200610L2-1