Pattern Result - ADTRAN TSU 610 User Manual

61200610L2-1
be run without the need for any external test equipment.
When QRSS is assigned to
link can be run along with normal data flow. The
are user assigned as part of the DS0 Map.
This sets the pattern for the test and initiates the transmission
of the pattern. The test is terminated by selecting
following patterns are available:
For example:
1. Use the up and down key to select
2. Press to record the selection. The TSU 610 starts to
Enter
generate a QRSS test pattern and inserts the pattern into
all DS0s.
3. Select to end the test.
None
QRSS always runs at 64K/DS0.

Pattern Result

Displays the results of the test currently active. Leaving and
returning to this menu item does not interrupt the test.
Pressing injects errors into the test pattern. These errors are
2
detected by the device performing the pattern check.
ES
The number of seconds with at least 1 bit error.
BES
The number of seconds with more than 1 bit error and less
than 320.
SES
The number of seconds with more than 320 bit errors.
SYNC
Indicates if pattern sync is (yes) or is not (no) valid. An
asterisk (*) indicates whether pattern sync has been lost since
the start of testing.
TSU 610 User Manual
Chapter 4. T1 Network Interface
, an integrity check of the
TST DS0s
QRSS ALL DS0s
TST DS0s
. The
None
.
4-29