Add New Unit; Modify Unit; Table 4-1. Unit Access Table (For T1) - ADTRAN TSU 610 User Manual

Chapter 4. T1 Network Interface
Unit ID
20
3
6
8

1) Add New Unit

2) Modify Unit

3) Delete Unit
4) Default Unit Passcode
5) OK
4-34
Units accessed via T-Watch Pro over TCP/IP use the Unit ID
and Passcode set by T-Watch Pro running on the PC.
Passcode
DEFAULT
0033
0095
0022
Add New Unit
This adds a new device to the table. You must enter a device
Unit ID, Passcode, Unit Type, and Polled Flag. The unit type
can be Standard (which supports any TSU/TDU Multiplexer
and the ISU 512) or TSU Standalone (a single port TSU with
no option card slot). You can select a passcode of
each device or
DEFAULT
be used.
Traps are normally sent from the unit in alarm to the TSU
610. For units in the Unit Access Table that are not chained
directly to the TSU 610 but are managed over Inband or the
FDL, traps are not automatically forwarded. Polling must be
enabled on the TSU 610 for these units in order to receive
traps on the NMS. The TSU 610 can be configured to poll
selected units for traps by enabling the polled option when
adding or modifying a unit entry.
Modify Unit
Allows Unit ID, Passcode, Device Type, and Polled Flag to be
changed for an existing entry in the table.
TSU 610 User Manual

Table 4-1. Unit Access Table (for T1)

Unit Access Table
Type
Standard
Standard
TSU Stand Alone
Standard
0022
, in which the default passcode will
Polled PollStatus
No
Yes UP
No
Yes UP
to
0 9999
61200610L2-1
for