Operation
ATTENTION!
►
The suction opening must always be open and may not be blocked .
Blockages lead to overheating and damage to the motor .
►
Use the wet-suction nozzle
NOTES
►
Make certain that the HEPA filter
►
When vacuuming liquid, do not exceed the MAX marking in the dirt
container
►
If the motorised brush attachment
longer turn, the charge indicator lamp
of the blockage, the working light
vacuuming . If this happens, remove the blockage as described in the section
"Cleaning the brush attachment" . Slide the On/Off switch
position . To restart the appliance, slide the On/Off switch
or II .
1) Remove the appliance from the wall bracket
wall bracket
2) If required, place the appropriate nozzle in the suction opening . See section
"Using accessories" .
3) To switch the appliance on, slide the On/Off switch
position I (= low power/wet suction
The charge indicator lamp
The working light
4) To switch the appliance off, place the On/Off switch
position . All lamps go out .
NOTE
►
After you have vacuumed up liquids, clean the dirt container i
immediately . Otherwise, bacteria or mould will build up inside! Ensure that
the HEPA filter
■
12
│
GB │ IE
only at level I (low/wet suction
5
.
i
, remove the barrel plug
7
lights up yellow at level I, green at level II .
w
lights up .
t
is completely dry before using the appliance again .
z
is inserted before using the appliance .
z
is blocked so that the brush can no
6
flashes red after approx . 15 seconds
w
goes out and the appliance stops
t
or, if you are not using the
7
from the socket .
9
q
) or position II (= high power) .
q
) .
to the "OFF"
q
to position I
q
forwards into
back to the "OFF"
SAST 18 A1