Setting Cooking Durations - Miele DG 7440 Operating And Installation Instructions

Operation

Setting cooking durations

Cooking results can be impaired if
there is a long delay between the
food being placed in the oven and
the start of cooking. Fresh food can
change colour and even spoil.
Select as short as possible a time
until the cooking programme starts.
You have placed the food in the oven
compartment, selected an operating
mode and the required settings such as
the temperature.
By entering Duration
via the  sensor control, you can auto-
matically switch the cooking process off
or on and off.
- Duration
Enter the required cooking duration
for the food. The heating will switch
off automatically once this duration
has elapsed. The maximum cooking
duration that can be set depends on
the operating mode that you have se-
lected.
- Finish at
Specify when you want the cooking
process to end. The oven heating will
switch off automatically at the time
you have set.
-
Start at
This function will only appear in the
menu if you have set a
time. With
ish at
specify when you want the cooking
process to start. The oven heating
will switch on automatically at the
time you have set.
48
, Finish at or Start at
Duration or
, you have to
Start at
 Select the  sensor control.
 Set the desired times.
 Confirm with OK.
 Touch the  sensor control to return
to the menu for the selected operat-
ing mode.
Tip: You can also adjust the cooking
duration directly via the navigation area.
The cooking duration does not begin
until the set temperature is reached.
If you are cooking at a temperature of
approx. 80 °C or above,
tion will appear in the display shortly
before the end of the cooking duration
and the door will automatically open a
little.
 Wait until
the display before opening the door
and removing the food from the oven.
A new cooking programme can only
be started if the automatic door re-
lease is retracted into its original po-
sition. Do not push it in manually as
this could damage it.
Fin-
Steam reduc-
goes out in
Steam reduction