Saxby Lighting Midi Wall Instruction Leaflet

Fitting/replacing bulbs
• During use the bulb and light fitting get very hot.
Always switch off at the mains and allow the bulb to
cool before replacing or adjusting the position of the
spotlight heads. Always use replacement bulbs of
the same type and never exceed maximum wattage.
Dispose of used bulbs carefully.
• To fit the bulbs, firstly unscrew the lampholder covers,
then insert the new bulbs before refitting the covers.
Make sure the seal is tight between the threads of the
lampholder covers and the light fitting body to ensure
effective ingress protection.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Do not clean the units with a pressure washer.
Glass parts - Remove and wash in warm water or just
use a damp cloth. Do not use abrasive materials as
these will damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by glass shades. These parts must be replaced immediately should the shades
become cracked or damaged. This fitting must not be used without the glass shades in place.
Replace Cracked
Shade
www.saxbylighting.com
35W GU10
Mains Halogen
G4719282: To prolong the life and keep your outdoor
lighting in good condition, it is recommended that
periodically it is cleaned using a soft cloth followed by
the application to metalwork of a light coating of oil,
such as WD40.
Iss.2 14/06/13
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
Midi Wall
G4719282, G4719206