Table of Contents
Advertisement
9.
APPENDIX
9.1
Maintenance
EPIRBs require little maintenance except periodic cleaning, if required. Always use a damp
cloth to clean the case and dry thoroughly.
Do not use solvents or other cleaning fluids as this may cause the plastics to
!
deteriorate.
Ensure the antenna is clean and not permanently bent.
!
Should the EPIRB turn on during cleaning, make sure it is turned off as quickly as
!
possible by pressing and holding the ON/OFF Key until the LED flashes red twice
and release.
9.1.1 Every Month
During the EPIRB self test it is advised that the following inspection is performed.
•
Inspect the EPIRB for obvious signs of damage including the state of the
antenna. Any creases in the antenna may cause operation of the EPIRB to be
impaired.
•
Confirm that the EPIRB is securely mounted in the Auto Release Housing.
•
Inspect the lanyard to ensure it is not attached to any structures.
•
Confirm the battery is within the specified expiry date.
•
Confirm the HRU is within the specified expiry date (Two years after the
installation date).
•
Clean the EPIRB and mounting. It is recommended that the EPIRB is cleaned
only using a damp cloth.
9.1.2 Every 12 Months
•
Annual Test and Inspection:
Perform extended annual test according to IMO's MSC/Circ.1040 of 406
MHz satellite EPIRBs as required by SOLAS IV/15.9 (If required by SOLAS or
national regulation)
•
Perform a GNSS Test (see section 7.2)
14/11/2022
EPIRB3 Pro USER MANUAL
912S-03968 - 01.02
27
Advertisement
Table of Contents
