Ocean Signal EPIRB3 Pro User Manual page 23

7.2.2 LED Indications with RLS Enabled
No. of
Flashes
1
2
3
4
5
6
7.2.3 LED Indications for units configured with non-RLS Protocol
No. of
Flashes
1
2
3
4
5
6
Because this test transmits a short burst on the aircraft distress frequency of
!
121.5MHz, please only carry out this test in the first 5 minutes of each hour.
The battery must be replaced either prior to the expiry date shown on the rear
!
label or after the EPIRB3 Pro has been activated.
If, during a self test, the LED flashes magenta
!
not have sufficient energy to operate for the specified 24-hour period. Battery
replacement is recommended.
NOTE: The flash sequence will be repeated after a short pause and then the EPIRB3
Pro will automatically power off.
7.2.4 AIS Test
Two AIS transmissions will occur during a Functional Test indicating "EPIRB TEST" on AIS
receivers within range.
To visualise an indication of a successful AIS transmission during test always
!
ensure the AIS receiving unit is configured to react to EPIRB Test signals.
14/11/2022
EPIRB3 Pro USER MANUAL
Functional Test Pass
0 to 59min
2hrs to 3hrs 59min
4hrs to 5hrs 59min
6hrs to 7hrs 59min
8hrs to 9hrs 59min
10hrs +
Functional Test Pass
0 to 59min
2hrs to 3hrs 59min
4hrs to 5hrs 59min
6hrs to 7hrs 59min
8hrs to 9hrs 59min
10hrs +
912S-03968 - 01.02
1hr to 1hr 59min
1hr to 1hr 59min
or amber
Fail
121.5MHz homer
406MHz power
AIS signal
AIS Power
Battery failure
No GNSS
Fail
121.5MHz homer
406MHz power
AIS signal
AIS Power
Battery failure
No GNSS
the EPIRB3 Pro may
23