Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ocean Signal PLB1
Summary of Contents for Ocean Signal PLB1
- Page 1 User Manual PLB1 Personal Locator Beacon English www.oceansignal.com...
- Page 2 The technical data, information and illustrations contained in this manual were believed to be correct at the time of print. Ocean Signal Ltd. reserve the right to change specifications and other information contained in this manual as part of our continual improvement process.
- Page 3 PLB1 USER MANUAL IN CASE OF EMERGENCY USE ONLY IN CASE OF GRAVE OR IMMINENT DANGER • PULL THE ANTENNA OUT FROM THE BODY TO ITS FULL EXTENT USING THE BLACK TAB • LIFT THE FLAP UP • PRESS THE ON KEY FOR ONE SECOND TO ACTIVATE THE BEACON.
-
Page 4: Table Of Contents
PLB1 USER MANUAL 1. GENERAL 1.1 Exposure to Electromagnetic Energy 1.2 Warnings 1.3 COSPAS/SARSAT System 2. PLB1 OVERVIEW 3. OPERATION 3.1 Activation 3.2 Deactivation 3.3 False Alerts 4. TESTING 4.1 Beacon Test 4.2 GPS Test 4.3 Special note for Commercial and DoD Users 5. -
Page 5: General
Your PLB1 contains lithium batteries. Please see section 5 for information on safe transportation. The battery in your PLB1 should be replaced immediately if it has been activated, or if the test indicator shows the battery as “used”, or if the expiry date marked on the unit has been exceeded. -
Page 6: Plb1 Overview
For non AUS/NZ customers the Flotation pouch is available as an accessory with part number 731S-04078. When attaching the PLB1 to a life jacket or other personal flotation device ALWAYS refer to the manufacturer's instructions for correct installation. Secure PLB1 using lanyard attachment Once affixed using the cradle or pouch, the PLB should be securely tethered to your person or clothing using the supplied lanyard. -
Page 7: Operation
MISUSE MAY RESULT IN A SEVERE PENALTY Ensure that your PLB1 is always fitted with an unused battery that is within the marked expiry date. Failure to do so may result in reduced operation time when used in a real emergency. Please observe the recommendations on testing in section 4. -
Page 8: Deactivation
False Alerts False alerts cause the rescue authorities unnecessary time and expense. To avoid false alerts make sure your PLB1 is safely stowed with the protective cover closed and the antenna fully wound in. Make sure that there is no excessive pressure applied to the protective cover. Ensure that anyone carrying the PLB1 is fully aware that this device is for emergen- cies and should only be used in situations of grave and imminent danger. -
Page 9: Testing
After all indicators have ceased flashing, the unit may still remain active for a short period of time. Routine testing of your PLB1 is recommended to ensure it is in good working order when needed. Ffollow the guidance notes below on the frequency that tests should be carried out. Remember that each test will reduce the battery capacity slightly and reduce the operation time of your PLB1 during an emergency. -
Page 10: Gps Test
PLB1 USER MANUAL GPS Test As testing the GPS Receiver expends significant amounts of battery energy do not test the GPS operation more than once year. Testing the GPS receiver is limited to 10 tests over the lifetime of the battery, after this the GPS test will fail to activate. -
Page 11: Appendix
Disposal Care should be taken when disposing of your PLB1 should it be no longer required. It is recom- mended to remove the battery from the PLB1 by removing the case lid. The case screws are covered by the top label. -
Page 12: Specifications
PLB1 USER MANUAL Specifications 406Mhz Transmitter Frequency 406.037 MHz ±1KHz Output Power 5W Typical Modulation Phase ±1.1 Radians Pk (16K0G1D) Encoding Biphase L Rate 400 bps 121.5MHz Transmitter Frequency 121.5 MHz Output Power 25-100mW PEP Modulation Swept Tone AM (3K20A3X) -
Page 13: Approvals
The PLB1 is approved for use in Canada with AIS only under RSS287. 5.6.3 European Declaration of Conformity Hereby, Ocean Signal Ltd. declares that the radio equipment type PLB1 is in compliance with Direc- tive 2014/53/EU. Country of Intended Use (... -
Page 14: Warranty Information
Ocean Signal will at its discretion, repair or replace faulty product free of charge excluding the cost of shipping. Proof of purchase from the original purchaser shall be required in order for a warranty claim to be valid. All claims shall be made in writing to Ocean Signal or an approved service dealer or distributor. -
Page 15: Your Beacon Details
PLB1 USER MANUAL YOUR BEACON DETAILS In the event of a false activation please contact the nearest Coast Guard Centre or Rescue Coordina- tion Centre to explain that the PLB3 has been activated in error and there are no follow up rescue actions required. - Page 16 Ocean Signal Ltd. Unit 4, Ocivan Way Margate CT9 4NN United Kingdom info@oceansignal.com www.oceansignal.com...