Advertisement
.Within 5 seconds press in rapid
sequence (one at the time) all the
keys from left to right (see picture
4) (except the start) key until the
message "LINE TEST" appears (see
picture 5). All the luminous icons
will be activated.
TEST
STARTs: within 7 seconds from
"LINE
TEST" appearing, push the
"START/PAUSE" sensor at the bottom
To confirm the activation is successful,
the eeprom code will be shown on the
display (See Picture 6).
NB: at the end of the 7 seconds the
display will back to the welcome
message
3)
Activation phase execution
BE
AWARE: It should be pointed out that the activation phase (of the factory test) has a very short
duration (approximately 60 - 80 seconds), for that reason you need to pay attention to each stage
When the test ends without displaying errors it does not mean that all electromechanical /
electronic components present on the machine work
check is required, for others it is necessary to check that the corresponding current value, shown
on the power meter is correct (for example washing or drying resistance). If in doubt, it is
recommended to repeat the test focusing on the execution of the specific phase.
To find the position of the detergent drawer compartments, mentioned during the test phases,
refer to Picture 7. In the event that an error occurs, the test run will be interrupted and the
corresponding error code will appear on the display (See sample in Picture 8). The table with the
meanings and the suggested checks is available in Chapter 4.
Picture 7
I
D.R.
Any change or alteration whatsoever of this document is formally prohibited except with the previous consent of the issuer.
I
©
2019 – HAIER EUROPE SERVICE ITALIA
Picture 4
Picture 5
Picture 6
properly. For some components a visual
Picture 8
2
Advertisement
