Partial Document Or Photo Prints; Photo Smudges; Copy Troubleshooting; Copier Does Not Respond - Lexmark X2500 User Manual

Select a lower print
quality
Software may not be
installed correctly

Partial document or photo prints

Check document
placement
Check paper size

Photo smudges

Photo smudges

Copy troubleshooting

•
"Copier does not respond" on page 63
•
"Scanner unit does not close" on page 63
•
"Poor copy quality" on page 64
•
"Partial document or photo copies" on page 64

Copier does not respond

Check the control panel
for any blinking lights
Check power
Software may not be
installed correctly

Scanner unit does not close

Check for obstructions
1
From the software application, click File
2
Click Properties, Preferences, Options, or Setup.
3
Click Quality/Copies.
4
From the Quality/Speed area, select a lower print quality.
For more information, see "Software may not be installed correctly" on page 59.
Make sure the document or photo is loaded facedown on the scanner glass in the lower
right corner.
Make sure the paper size being used matches the size you selected.
To prevent smudging, avoid touching the surface of a printed photo. For best results,
remove each printed sheet individually from the paper exit tray, and allow the prints to dry
at least 24 hours before stacking, displaying, or storing.
If one of the lights is blinking, see "Blinking lights on the control panel" on page 70.
If the light is not on, see "Power button is not lit" on page 58.
For more information, see "Software may not be installed correctly" on page 60.
1
Lift the scanner unit.
2
Remove any obstruction keeping the scanner unit open.
3
Lower the scanner unit.
Troubleshooting
Print.
63