Perform Engine Maintenance - Deutz Models; Inspect For Turntable Bearing Wear - Genie Z-45/25 Service Manual

June 2005
REV D
D-6
Perform Engine Maintenance -
Deutz Models
Deutz engine specifications require
that this procedure be performed
every 1000 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 1011F Operation Manual
(Deutz part number 0297 9683).
Deutz FL 1011F Operation Manual
Genie part number
To access the engine:
1 Remove the safety pin from the engine pivot
plate latch.
The engine pivot plate latch is
located under the engine turntable
pivot plate at the counterweight
end of the machine.
2 Open the engine pivot plate latch and swing the
engine pivot plate out and away from the
machine.
Part No. 77809
Section 3 • Scheduled Maintenance Procedures
D-7
Inspect for Turntable Bearing
Wear
Periodic inspection of turntable bearing wear is
essential to safe machine operation, good machine
performance and service life. Continued use of a
worn turntable bearing could create an unsafe
operating condition, resulting in death or serious
injury and component damage.
1 Grease the turntable bearing. See A-13, Grease
the Turntable Bearing and Rotate Gear.
2 Torque the turntable bearing bolts to
specification. See D-2, Check the Turntable
52883
Rotation Bearing Bolts.
3 Start the machine from the ground controls and
raise the primary and secondary booms to full
height. Do not extend the primary boom.
Z-45/25 • Z-45/25J
CHECKLIST D PROCEDURES
Perform this procedure with the
machine on a firm, level surface
and the boom in the stowed
position.
3 - 45