NiteRider MiNewt Mini 300-USB Quick Start Manual

MiNewt Mini 300 – USB
MiNewt Mini 300 – USB Plus
Discover the Night!
Thank you for choosing the MiNewt Mini 300 - USB™ from NiteRider, the leading innovator in
technical lighting systems. The MiNewt Mini 300 - USB™ combines a high-powered white LED
headlamp and a Power Module containing light control, charging and safety circuits as well as the
rechargeable Lithium Ion battery.
To get the most from your NiteRider light, we urge you to familiarize yourself with the following
safety and operating instructions.
Riding at Night
While the MiNewt Mini-USB™ will improve your control and enjoyment of night riding, please
remember that cycling at night is an inherently dangerous activity. In addition to using your lighting
system properly and riding with extreme caution, NiteRider urges you to:
• Never ride alone
• Always let someone know where you are going
• Wear a helmet and reflective clothing
• Carry an auxiliary light and emergency supplies
Protecting Your Investment
When not in use, always disconnect the headlamp from the power module. To unplug, grasp the
connector, not the cable. Properly charge your batteries to maximize their lifespan. Be sure to use
only the supplied AC Adapter, otherwise damage to the power module circuitry could occur.
The MiNewt Mini-USB™ will perform in wet weather conditions, but submerging it in water will
damage the system.
Support If you experience difficulties during product installation or operation, NiteRider provides
free telephone support on weekdays from 8:00 AM to 4:30 PM (Pacific Time) at
800.466.8366, ext. 4. You may also e-mail us at support@niterider.com.
Warranty
NiteRider stands behind its products with the following MiNewt Mini-USB™ warranties:
• Lifetime warranty on all mechanical components
• 2 years on the headlamp, power module
(excluding degradation of the battery cells) and AC Adapter
• 180 days on rechargeable batteries
To repair or replace your product while under warranty, return it (postage prepaid and insured with
original sales receipt) to the address below. Out-of-warranty repair service is also available.
For complete warranty information, please visit our website at www.niterider.com.
Operation
1. Connect the headlamp cord to the Power Module.
2. Press and release the headlamp power button to turn the light on. Cycle through the three
brightness levels by pressing and releasing the power button.
3. To access the daylight visible flash mode, press and hold the power button for greater than 3
seconds.
4. To turn the light off from either normal or flash mode, press and hold the power button for
greater than 1 and less than 3 seconds.